Installation Gallery
Installation Gallery

1. Step One
Check all parts are included

2. Step Two
Assemble the seat by raising the front platform and securing the center support arm with the blue screw and one of the washers.

3. Step Three
Attach the receiver to your bicycle seat post. There must be at least 1.75 inches of post exposed below the seat to make this connection. Keep this connection as high up the seat post as possible. This will give the rider more legroom when peddling.

4. Step Four
Install the metal support arm and position the seat on the arm as far forward as possible without interfering with your handle bars or steering post.
Mark this position with a small pencil mark on the bar behind the pet seat. Remove the pet seat and then remove the metal support arm from the bike using the quick release pin.

5. Step Five
Using the four red screws and washers provided, mount the pet seat to the metal bar. Make sure all four screws are in position before tightening.

6. Step Six
Install the assembled pet seat to the bicycle using the quick release pin and be sure to secure that with the cotter pin provided or a small pad lock.

7. Step Seven
Assemble the harness as shown and adjust to fit your dog following the instruction sheet provided.

8. Step Eight
Before attempting to ride with your little buddy, you may want to get them comfortable in the seat first while it is on the ground. Try treats to entice them to sit in the Buddyrider if they hesitate to get in.
Enjoy and have fun!